NOTICE: Our prices are being reviewed and will be changed on the 1st of January, 2018.

Installation & Maintenance

Care Instructions

Your new original Cush'n Soft padded toilet seat is manufactured from high quality materials for durability and your protection and comfort.

Please follow the instructions below to get the best out of your seat.

As a rule the less chemical used on your seat the longer the vinyl will last. Using strong cleaners in the bowl of your toilet is fine but when doing so lift the complete seat into the upright position especially when products are left in the bowl overnight.

  • Washing your seat with a mixture of soapy water and a little bleach is probably the best option.
  • Although most spray and wipe products are fine.
  • Do not use cleaners that contain phenol or are abrasive as this will void the warranty.
  • Do not stand or place anything sharp or hot on your seat that may damage the vinyl.
  • Do not use 'drop on' child trainer seats as they can damage the vinyls. Cush'n Soft manufactures a junior seat for the young child.
  • Do not sit on the lid of your Cush'n Soft seat.

Products that have discoloured Cush'n Soft seats are:

  • Pine O Cleen
  • Domestos
  • Detol
  • All products that contain phenol

Seat Installation – Cush’n Soft and Cush’n Soft Junior

Thank you for purchasing a Cush’n Soft toilet seat. The best way to install your seat is as follows:

  1. Slide the 2 nylon ‘t’ bolts into the hinge blocks on the back of seat
  2. Place the seat on the pan ensuing the bolts are guided through the holes in the pan
  3. Place a nylon washer then the nylon wing nut on the bolts protruding through the pan
  4. With out tightening the bolts centre the seat on the pan
  5. Tighten wing nuts firmly

Fitting instructions- Base only

Thank you for purchasing a Cush’n Soft base only. The best way to replace the base on your seat is as follows:

  1. Lift the complete seat into the upright position
  2. Place a towel over the pan to stop screws from accidentally falling into the bowl.
  3. Remove the 4 stainless Phillips screws from the underneath of the seat.
  4. Remove the old seat and put the new seat into position
  5. Replace the screws and tighten firmly
All prices are in Australian Dollars and are inclusive of GST | ph: +61 (0)2 9505 8600 | ABN: 76 389 462 946 | Copyright © 2017 Cushn Soft 2000 | Angelight Web Design